Захотелось подружить Cisco 4948 c 122-54.SG и древний Picolight SFP модуль, по злой рок в виде
C4K_CHASSIS-3-SFPINTEGRITYCHECKFAILED:SFP
не давал этим двум славным железкам слиться в экстазе. Подружить негодников удалось 3мя волшебными стопарями^W командами:
service unsupported-transceiver no errdisable detect cause gbic-invalid errdisable recovery cause gbic-invalid
и, аллелуя!
CoreSwitchA#show interfaces gi1/45 controller GigabitEthernet1/45 is up, line protocol is up (connected) Hardware is Gigabit Ethernet Port, address is 0024.9760.372c (bia 0024.9760.372c) MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex, 1000Mb/s, link type is auto, media type is 1000-DWDM-38.19 Media-type configured as SFP connector
CoreSwitchA#show idprom interface gi1/45 GBIC Serial EEPROM Contents: Common Block: Identifier = Not available [0x3] Extended Id = GBIC is compliant with MOD_DEF 4 [0x4] Connector = LC Connector [0x7] Transceiver Type = Gbic DWDM-3819 Speed(FC,byte 10)= 100 MBytes/Sec 200 MBytes/Sec [0x5] Media = Multi-mode, 50u (M5) Multi-mode, 62.5u (M6) [0xC] Technology = Shortwave laser w/o OFC (SN) [0x40] Link Length = Intermediate Distance [0x20] GE Comp Codes = Not available [0x0] SONET Comp Codes = Not available [0x0] 10GE Comp Codes = Extended [0x0] Encoding = 8B10B [0x1] BR, Nominal = 2100 Mbps (million bits per second) Length(9u) in km = GBIC does not support single mode fibre, or the length must be determined from the transceiver technology. Length(9u) = GBIC does not support single mode fibre, or the length must be determined from the transceiver technology. Length(50u) = 300 m Length(62.5u) = 150 m Length(Copper) = GBIC does not support copper cables, or the length must be determined from the transceiver technology. Vendor name = PICOLIGHT Vendor OUI = 1157 Vendor Part No. = PL-XPL-00-S23-24 Vendor Part Rev. = Unspecified Wavelength = 850 nanometers CC_BASE = 0x65 Extended ID Fields Options = Loss of Signal implemented TX_FAULT signal implemented TX_DISABLE is implemented and disables the serial output [0x1A] BR, max = 4% BR, min = 52% Vendor Serial No. = 231CL0QB Date code = 020809 Diag monitoring = Not implemented Rx pwr measuremnt = Optical Modulation Amplitude (OMA) Address change = Not required CC_EXT = 0xAD
делись@распространяй